Babycare-tens Elle TENS User Manual download pdf (Page 20)

Display

Using the Elle TENS+ in PAIN mode

Entering PAIN mode

a). Switch the unit ON by pressing the On/Off Button. Note that your Elle TENS+

will always start up in perviously used mode. You need to select ‘PAIN’.

b). If the unit does not already display ‘PAIN’ press the Opti-Max Key to cycle

through the 3 available modes, (BIRTH, PAIN, PELVIC) until ‘PAIN’ flashes at

the top of the display as shown in the diagram.

c). Press the Mode Button to confirm ‘PAIN’ mode, otherwise your Elle TENS+

will automatically enter PAIN mode after a few seconds. To select another

mode you must first turn off the unit and follow instructions as in a) above.

Adjusting intensity for pain relief

Begin by pressing the CH1+ key. Each time this key is pressed, ‘half-moons’

will appear on the screen increasing in number and size as the intensity is

increased. You will begin to feel a tingling sensation. Press CH1- should you

wish to reduce the intensity.

Opti

Max

Mode

CH1

Press

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 35 36

No comments

Babycare-tens Elle TENS User Manual Page 20