Babycare TENS Obi TENS Service Manual download pdf (Page 6)

Setting up your Obi TENS

Check you have the following contents:

• 1 x Obi TENS unit

• 1 x Pack of 4 self adhesive electrodes

(40mm x 100mm)

• 2 x Leadwires (1 for use and 1 spare)

• 4 x AAA batteries (2 for use and 2 spare)

• 1 x Carrying pouch

• 1 x Easy-release neck cord

• 1 x Instruction manual

The assembly stage

1. Slide open the battery cover on the back of the

unit to expose the battery compartment.

2. Insert 2 x AAA batteries according to the

diagram found in the battery compartment.

Replace the cover.

a) Take one of the mauve and white leadwires and

insert the white jack plug at the end of the lead

into the socket at the bottom of the Obi TENS

unit. (Save the other leadwire as a spare)

b) Now insert the red and white pins (at the other

end of the leadwire) into the sockets attached

to the sticky electrodes. You will see that the

lead wire is made up of 4 wires; 2 mauve and 2

white. Do not remove the electrodes from the

backing at this stage (see figure below). NB.

Each leadwire has a red and white pin at the

end. It makes NO difference whatsoever which

electrode they are attached to!

c) If you wish, attach the easy-release neck cord

which enables you to hang the Obi TENS from

your neck whilst in labour.

Insert a red and black pin

(at the end of the lead wire)

into each pair of electrodes.

4316 Obi TENS Instr.qx7:Layout 1 15/6/09 14:19 Page 6

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Babycare TENS Obi TENS Service Manual Page 6